Seas APHEL Kit uten kabinett, Nytt Seas kit!

Beskrivelse

This loudspeaker kit was made with the help of a local DIY enthusiast. It’s an old school design with a wide baffle on a large box that is fitted with an 8″ woofer and a 1″ dome. The inspiration for the kit rests on SEAS kits from the 70’s and classic designs from the likes of Snell. This is all about putting the music first and just pure enjoyment.

Drive units
The tweeter is the well proven 1″ SEAS Prestige aluminium dome tweeter 27TBFC/G. The aluminium dome is produced in house to meet our strict demands for a consistent performance. It’s made with ferrofluid in the air gap to provide good cooling and so that it can be used with a low crossover point. This is quite important when it’s matched with a large woofer like it is in this kit.

The low end and midrange is taken care of by the classic SEAS Prestige coated paper cone woofer, CA22RNY. This has a large magnet system to boost the sensitivity, while the coated paper cone deilvers a smooth response all the way up through the midrange. That makes this driver easy to filter and enjoy.

The Enclosure
The enclosure was chosen to be a big 55L box with a wide baffle and a port tuned to 36Hz. This is larger than the traditional QB3 alignment used in many ported designs, but gives the loudspeaker a warm and full bodied bass.

The wider baffle helps to lower the baffle step frequency and to put some more presence into the lower midrange.

Inside the cabinet the walls are fitted with 4mm bitumen and then 10mm of wool felt. Above the lower brace the cabinet is loosely filled with polyester foam all the way to the top. There is no foam around the port, since this dulled the sound too much.

The port in the cabinet can be made longer when you first assemble the kit, and then shorten it after listening to find your optimum bass balance to fit the room and personal preference.

The Crossover
Here we aimed for a slightly tilted response that is favoured by many listeners. This is achieved with a 3rd order filter on both drivers with some resistors to fine tune the slopes. The tweeter also has an L-pad to adjust the sensitivity. On the series resistor for the tweeter we’ve also put a small shorting capacitor to lift the very top end of the frequency response.

The R3 resistor can be adjusted between 10 Ω and 22 Ω to adjust the tweeter level.

For those who want to experience with their own crossover design or fine tuning, there are some more options. We have added the raw data of the drivers in the cabinet and a setup file for VituixCAD in a zip file for download on top of the page, «Download SEAS APHEL files». Then you can play around with both passive and active designs.

Measurement Results
The on-axis measurement of the SEAS Aphel kit, including the individual drivers and a measurement with the tweeter polarity inverted, see product pictures. The crossover frequency is at 2240Hz. From the inverted tweeter polarity measurement we see that it gives a deep cancellation that tells us that the drivers are in phase.

Listening Room and Placement
Some experimentation is recommended in order to find cabinet positions and \mbox{toe-in} which result in a good tonal balance and defined sound stage in your listening room.

It is also advised to test a small stand or a tilted base to direct the tweeter axis closer to the ear level of your listening sweet spot..